Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PEAP configuration in AP 1100

How to configure for peap in AP 1100 through CLI

2 REPLIES
Cisco Employee

Re: PEAP configuration in AP 1100

Hi Sanjoy2006.

This may depend on which IOS version you are running on your 1100 series access points. Here is a link to the configuration guides for the 1100. You can select the applicable software version and the section you would look for would be "configuring authentication types". Here is the link to the wireless configuration guide page:

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_installation_and_configuration_guides_list.html

Another resource which might be helpful includes the AAA - Access Control Server - Configuration guidelines as well as some info about CLI configuration of the access points. This can be found here:

http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_configuration_example09186a0080545a29.shtml

Hope this helps

Cisco Employee

Re: PEAP configuration in AP 1100

Following link can give you information on configuration of EAP through GUI and CLI:

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_example09186a00801bd035.shtml

Remember PEAP is not something which you setup on AP, AP has a default configuration to allow EAP protocol.

The settings related to protocol selection like PEAP, EAP-TLS etc needs to be done on Radius Server and Client machines.

Following link can give information on configuration of Radius server and client machines:

http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_configuration_example09186a00801df0e4.shtml

Hope this helps.

~Rohit

152
Views
0
Helpful
2
Replies
CreatePlease to create content