Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Physical Port WLC

I can configure the distribution port to 100Mbps FullDuplex?

4 REPLIES
Hall of Fame Super Red

Re: Physical Port WLC

Hi Ricardo,

Q. The physical ports on the controller are currently set to operate at 1000 mbps speed. Is it possible to change this port speed to 100 mbps?

A. No, the port speed on the controller cannot be changed. These are set at 1000 mbps, full duplex speed only.

http://www.cisco.com/en/US/products/ps6366/products_qanda_item09186a008064a991.shtml

Hope this helps!

Rob

New Member

Re: Physical Port WLC

Rob, but in the CLI of the wireless lan controllers, these command are available:

(Cisco Controller) >show port summary

STP Admin Physical Physical Link Link Mcast

Pr Type Stat Mode Mode Status Status Trap Appliance POE

-- ------- ---- ------- ---------- ---------- ------ ------- --------- -------

1 Normal Forw Enable Auto 1000 Full Up Enable Enable N/A

2 Normal Disa Enable Auto 1000 Full Down Enable Enable N/A

3 Normal Disa Enable Auto 1000 Full Down Enable Enable N/A

4 Normal Disa Enable Auto 1000 Full Down Enable Enable N/A

(Cisco Controller) config>port physicalmode 1 ?

[100h/100f/10h/10f] Enter port speed and duplex setting.

???

New Member

Re: Physical Port WLC

Even though those commands are there they will not work. GBIC ports like these cannot be changed from 1G full.

New Member

Re: Physical Port WLC

Hi Ricardo -

What model of WLC is this?

255
Views
0
Helpful
4
Replies
CreatePlease to create content