We have one site about 3 blocks away that connects to our main office with a wireless point to point connection. We had some issues with the old hardware so we've replaced them with a couple of Cisco BR350 bridges that we had lying around. Not the most current gear but it was working fine at another site so we thought we'd try it.
The site came up without too much issue, however now it is randomly disconnecting throughout the day, and I have to reboot the root bridge to get the conenction to come back up. The far side bridge is logging:
Yes, I updated both bridges with the latest firmware. The antennas were professionally installed several years ago and have been in use for quite some time so I assume they are both the same. One is on a 50ft tower and the other is on a roof so I can't really get to them or see any obstructions.
It's about a half mile between sites and just driving along the path I cannot see anything that would be a new obstruction. As I said this wireless shot has been in place for several years.
I'm having a hard time with the telnet console for these so I'm working on posting a config.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...