Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

poor connection power AP1232AG-A-K9

Cannot get more than 40 percent connecion power even when directly under the AP. Using Cisco CB21AG-A-K9 cards in Toshiba M4400 tablet. We set the cards to use the A radio at 5220Mhz CH 4 transmit power of 11dBm The A radio is a Air-RM22A. Do not understand why I cannot get better reception from this AP.

4 REPLIES
Silver

Re: poor connection power AP1232AG-A-K9

Interference and noise could cause reduced signal strength. Try changing the channel on the access point .

New Member

Re: poor connection power AP1232AG-A-K9

Thanks,

Sorry for the delay. Had already looked at that and believe that the AC unit above the area may have been causing some problems, however, moved AP's and still getting same problem.???????

Bronze

Re: poor connection power AP1232AG-A-K9

Are you using the right antenna, if you are using a 2.4 antenna this may cause the problem. check the this reference for the proper antenna. the 2.4 and 5.8 rubber ducks look very similar.

http://www.cisco.com/en/US/products/ps6108/products_data_sheet09186a008022b11b.html

Bill

Hall of Fame Super Silver

Re: poor connection power AP1232AG-A-K9

Also make sure the antennas are in the correct connectors. If the Ap's are pretty high up, you will have a weaker signal directly under the AP.

-Scott
*** Please rate helpful posts ***
138
Views
0
Helpful
4
Replies