Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Power client local parameter don't stay after reboot

Hello,

I have existing AP configuration on my network with AP1130AG-E-K9. My configuration is based on hidden SSID with WPA TKIP passphrase.

I have Motorola Symbol connected on this SSID. To connect this device i have set "power client local" on each Dot11radio.

Recently a bought SAP1602E with external antenna (ANT2524DW-R) to enable wireless in a warehouse.

"Power client local" don't stay after reboot AP.

I tried to enable-disable "aironet extention" and applied antenna gain to 2 and 4 on dot11radio by telnet and web management, but it's the same things.

this is my configuration:

interface Dot11Radio0
no ip address
no ip route-cache
!
encryption mode ciphers tkip
!
encryption vlan 1 mode ciphers tkip
!
ssid SSID
!
antenna gain 2
stbc
beamform ofdm
station-role root
!
interface Dot11Radio0.1
encapsulation dot1Q 1 native
no ip route-cache
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
!

interface Dot11Radio1

no ip address

no ip route-cache

!

encryption mode ciphers tkip

!

encryption vlan 1 mode ciphers tkip

!

ssid SSID

!

antenna gain 4

no dfs band block

stbc

beamform ofdm

channel dfs

station-role root

!

interface Dot11Radio1.1

encapsulation dot1Q 1 native

no ip route-cache

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 spanning-disabled

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

Thank for help.

171
Views
0
Helpful
0
Replies
CreatePlease to create content