Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Power Cycle on POE ports with 1020 APs

We have 1020 access points with a combination of 4402 and 4136 controllers. We can watch the log in the 3750 switch and see them power cycle randomly. This, of course, is causing outages for the users. Has anyone seen this?

From our log:

May 18 10:38:14: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet2/0/42, changed state to down

May 18 10:38:15: %LINK-3-UPDOWN: Interface FastEthernet2/0/42, changed state to down

May 18 10:38:22: %LINK-3-UPDOWN: Interface FastEthernet2/0/42, changed state to up

May 18 10:38:23: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet2/0/42, changed state to up

May 18 10:38:27: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet2/0/42, changed state to down

May 18 10:38:29: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet2/0/42, changed state to up

3 REPLIES
New Member

Re: Power Cycle on POE ports with 1020 APs

This would indicate an AP reboot... check the management screen of the controller for AP logs, and check the message logs for AP resets ("last AP reset due to XXX"

New Member

Re: Power Cycle on POE ports with 1020 APs

I almost agree. The issue is that the down time is ~15 seconds. A typical reboot takes upwards of 60.

The controller doesn't log this as a reset. It doesn't log anything at all.

New Member

Re: Power Cycle on POE ports with 1020 APs

Forgive the question, but are you on 3.2.116.21?

I noticed in the release notes that one of the items they fixed in the release was random reboots.

254
Views
0
Helpful
3
Replies
CreatePlease to create content