Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Power to 521 Access Points

I am trying to Power a Cisco 521 AP from a blade on a 4500 switch. The blade module number is WS-X4548-GB-RJ45V. This is supposed to be a POE blade, but when I plug the AP in, I do not get the AP to power up.

5 REPLIES
Hall of Fame Super Blue

Re: Power to 521 Access Points

What is the IOS you are currently running? What is your Supervisor card?

Check the ports. See if "power inline never" is on the config.

Community Member

Re: Power to 521 Access Points

thanks for the response. It is actually configured for :power inline auto: on the port.

But it shows a status of :off:

Hall of Fame Super Blue

Re: Power to 521 Access Points

Check your cable.

Community Member

Re: Power to 521 Access Points

I have tried using 2 different ethernet cables. Neither power up.

Hall of Fame Super Blue

Re: Power to 521 Access Points

Not familiar with this AP but are you sure you are plugging it into the FE port and not the console port?

139
Views
0
Helpful
5
Replies
CreatePlease to create content