Power transmission

[bws]

Hi,

i am having WLC 4400 controller, Product AIR-WLC4402-50-K9 with the Cisco AP AIR-AP1020-E-K9.

for some reason im willing to increase power transmission to better serve the Wireless network for different platforms.

Regs,

adil

[ankbhasi]

Hi Adil,

If you have the web access of your controller you can go to wireless section or wireless tab and can access the AP section where you can see the radio 1 and b/g section and you can see what power level they are working at.

You can also set the power level manually to to 1 which will provide the max power transmission.

HTH

Ankur

*Pls rate all helpfull post

[bws]

thanx for your help.

can i have any doc on this POWER level, which describes about them in detail.

Adil

[ankbhasi]

Hi Adil,

Have a look at this link which will tell you details about RRM (Radio Resource Management) Algorithm and how power can be dynamically as well as manually configured on controller.

For example, 1 = maximum power level in a particular regulatory domain, 2 = 50% power, 3 = 25% power, 4 = 12.5% power, and so on.

http://www.cisco.com/univercd/cc/td/doc/product/wireless/control/c44/ccfig40/c40rrm.htm#wp1100120

http://www.cisco.com/univercd/cc/td/doc/product/wireless/control/c44/ccfig40/c40rrm.htm#wp1104208

HTH

Ankur

*Pls rate all helpfull post

[johnruffing]

If you want to correlate % power with actual dB settings (you will have to add antenna gain separately if you have an external antenna), you might try this document (attached)

John