Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PPPOE on WLAN

Can this be done...

[Client]<---wlan-->[AP]<--eth-->[cisco1700]<---serial(leasedline)-->[3600(nas)]

What i'm doin is to enable pppoe over wlan. Can cisco AP bridge the

client to the nas. What are the requirements and settings for the AP/1700/3600

??

Can anyone give suggestions please.. thankss :)

  • Other Wireless - Mobility Subjects
1 REPLY
Cisco Employee

Re: PPPOE on WLAN

I assume PC running PPPoE client 3600 as aggregator for PPPoE tunnel, you need to have 1700 doing bridging..

But the better idea will be 1700 with PPPoE client and 3600 as Aggregator(something like PPPoE over serial)..So serial port getting dynamic or static ip address on 1700 and you can use NAT for the PC's connected on the ethernet WLAN..tejal

129
Views
0
Helpful
1
Replies
This widget could not be displayed.