Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Predownloading AP Image- 1240

I have 2 controllers that are currently on software version 7.3.  I am planning on upgrading to 7.4MR2(7.4.121) and have not performed the pre-download process before.  In reading some of the restrictions, I am somewhat concerned with this.

Predownloading a 7.2 or later version of image on a Cisco Aironet 1240 access point is not supported

when upgrading from a previous controller release. If predownloading is attempted to the Cisco Aironet

1240 access point, the AP gets disconnected.

We do still have several 1240 AP's.  Does this only apply with you are upgrading from a release prior to 7.2?  Can someone please clarify?  Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Predownloading AP Image- 1240

There is not enough memory to be able to download a second image.  These AP's do not support it and the only way to upgrade them is to upgrade the WLC and reboot the WLC.  These will join and get the new image from the WLC.

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***
2 REPLIES
Hall of Fame Super Silver

Predownloading AP Image- 1240

There is not enough memory to be able to download a second image.  These AP's do not support it and the only way to upgrade them is to upgrade the WLC and reboot the WLC.  These will join and get the new image from the WLC.

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***
New Member

Re: Predownloading AP Image- 1240

Thanks. That's what I thought.

Sent from Cisco Technical Support iPhone App

192
Views
0
Helpful
2
Replies
CreatePlease to create content