Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Probe information with RSSI for specific LWAPP AP on a WLC?

Hello,

I am using Cisco WLC 4400 and four Aironet 1242 LWAPP.

I would like to get detailed informations about RSSI of all probing clients (rouge clients, associated clients, and all the other devices that are just probing for a wlan).

It would be great if I could have last information via SNMP, but I looked for some MIB and I found only some of them about Associated Clients and Rouge Clients and Rougue AP. Is there some MIB I didn't find?

Enabling debug for probes, I can see probing devices with Signal Strenght and RSSI, such this:

*apfProbeThread: Jan 23 16:02:16.548: Received aggregated probe, dataLen = 69

*apfProbeThread: Jan 23 16:02:16.548: e1:18:ac:dd:1b:00 aggregated probe IE elmId=221, elm_len=9, dataLen=69

*apfProbeThread: Jan 23 16:02:16.548: aggregated probe IE: TIMESTAMP

*apfProbeThread: Jan 23 16:02:16.548: 14:da:e9:45:25:d0 aggregated probe IE elmId=221, elm_len=27, dataLen=58

*apfProbeThread: Jan 23 16:02:16.548: 14:da:e9:45:25:d0 aggregated probe IE: AGGR PROBE

*apfProbeThread: Jan 23 16:02:16.548: 14:da:e9:45:25:d0 probing client, ver=1, slot=0, wlan=0, snr=17, tx_pwr=0, chan=1, reg_class=0, ts_diff=197ms, seq_num=4100, ant_cnt=2, rssi[0]=181, rssi[1]=128

*apfProbeThread: Jan 23 16:02:16.548: 14:da:e9:45:25:d0 aggregated probe IE elmId=221, elm_len=27, dataLen=29

*apfProbeThread: Jan 23 16:02:16.548: 14:da:e9:45:25:d0 aggregated probe IE: AGGR PROBE

*apfProbeThread: Jan 23 16:02:16.548: 14:da:e9:45:25:d0 probing client, ver=1, slot=0, wlan=0, snr=12, tx_pwr=0, chan=1, reg_class=0, ts_diff=137ms, seq_num=4096, ant_cnt=2, rssi[0]=173, rssi[1]=154

How can I distinguish received probes between different APs associated to the WLC? I would like to know which AP received a probe and its RSSI.

Thank you very much

Everyone's tags (4)
1 REPLY
New Member

Hi,I am not sure I understood

Hi,

I am not sure I understood how you manage to get the probing information out of the controler.

could you give us the whole command ?

I am trying to get the RSSI information of probing clients out of the WLC.

Best

425
Views
0
Helpful
1
Replies
CreatePlease login to create content