05-04-2007 07:02 AM - edited 07-03-2021 02:01 PM
Hi all,
My AP1220(VxWorks) don't boot up after I tried to reset his password. After 2sec he shows all 3 LEDs in steady green.
Console shows this info at boot time
esting DRAM...
(press <esc> to bypass)
DRAM OK
Power-on reset.
Copyright 1996-2000 Cisco Systems, Inc.
Copyright 1984-2000 Wind River Systems, Inc.
System ID: 0012000207A6
Motherboard: IBM405 200MHz, 8192KB FLASH, 16384KB DRAM, Revision 05
Bootstrap Ver. 1.00: FLASH, CRC 1C914641 (OK)
Initialization: OK
and that's all
What to do with AP?
How to load new VXWorks or IOS image??
thank you for advice
05-04-2007 09:03 AM
Hi Kestutis,
Have a look at the following;
Verify that the connection settings in the terminal application are 9600-8-None-1 and NO flow control (not hardware or software).
From this doc;
Recover from a Failure
Reset the VxWorks AP;
Part of this comprhensive doc;
Upgrade Cisco Aironet AP1200 to IOS
http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a008019fea0.shtml
Hope this helps!
Rob
05-04-2007 09:05 PM
Nothing helps. First I didn't upgrade my 1200Vx to IOS. Problem arised after I tried to reset password. So first place:I need to boot AP to normal VxWorks or some Rommon mode.
In my case I can't input any characters and I don't see any menu except output in hyperterminal (previous mentioned).
thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: