Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

problem AP 1220B don't boot up

Hi all,

My AP1220(VxWorks) don't boot up after I tried to reset his password. After 2sec he shows all 3 LEDs in steady green.

Console shows this info at boot time

esting DRAM...

(press <esc> to bypass)

DRAM OK

Power-on reset.

Copyright 1996-2000 Cisco Systems, Inc.

Copyright 1984-2000 Wind River Systems, Inc.

System ID: 0012000207A6

Motherboard: IBM405 200MHz, 8192KB FLASH, 16384KB DRAM, Revision 05

Bootstrap Ver. 1.00: FLASH, CRC 1C914641 (OK)

Initialization: OK

and that's all

What to do with AP?

How to load new VXWorks or IOS image??

thank you for advice

2 REPLIES
Hall of Fame Super Red

Re: problem AP 1220B don't boot up

Hi Kestutis,

Have a look at the following;

Verify that the connection settings in the terminal application are 9600-8-None-1 and NO flow control (not hardware or software).

From this doc;

Recover from a Failure

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a008019fea0.shtml#topic2

Reset the VxWorks AP;

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_password_recovery09186a00800949d0.shtml

Part of this comprhensive doc;

Upgrade Cisco Aironet AP1200 to IOS

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a008019fea0.shtml

Hope this helps!

Rob

New Member

Re: problem AP 1220B don't boot up

Nothing helps. First I didn't upgrade my 1200Vx to IOS. Problem arised after I tried to reset password. So first place:I need to boot AP to normal VxWorks or some Rommon mode.

In my case I can't input any characters and I don't see any menu except output in hyperterminal (previous mentioned).

thanks

137
Views
0
Helpful
2
Replies