Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Problem Configuring 1252s

I have a lot of 1200-series and 1100-series APs, but I've got several new 1252 APs I am configuring for the first time.  Everything is going as expected until I get to the "Services" settings (for setting SNMP, HTTP, etc).

When I click on the Services tab (using the GUI), I get the Cisco logo and page header, but the rest of the page is blank.  None of the sub-menus appear.  I can successfully set the Services via CLI, but why isn't it showing up on the GUI ?

Screenshot below

Image1.jpgImage1.jpg

dennis.kline@yahoo.com (It takes an Act of God to fade a wireless path, but any fool with a backhoe can cut fiber)
3 REPLIES
Cisco Employee

Re: Problem Configuring 1252s

have you tried reloading the AP and tested??

Regards

Surendra

New Member

Re: Problem Configuring 1252s

yeah.. It's 6 APs, fresh out of the box.

dennis.kline@yahoo.com (It takes an Act of God to fade a wireless path, but any fool with a backhoe can cut fiber)
Hall of Fame Super Gold

Re: Problem Configuring 1252s

Maybe you just need to re-load the IOS.

294
Views
0
Helpful
3
Replies
CreatePlease to create content