cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
382
Views
0
Helpful
3
Replies

Problem with 851

mbjohnson
Level 1
Level 1

Hi all,

I've never worked with the 851 on the wireless side of things and I'm having a really hard time getting this thing to let me connect with my laptop and give me an IP address. I just want to setup something fairly simple with an SSID (non broadcast), WPA password etc for home use. Here's what I have currently:

interface Dot11Radio0

no ip address

ip nat inside

ip virtual-reassembly

!

encryption key 3 size 128bit ***** transmit-key

encryption mode ciphers tkip wep128

!

ssid CICSOTEST

authentication open

authentication key-management wpa optional

wpa-psk ascii 7 ********

!

speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0

54.0

station-role root

no dot11 extension aironet

What am I doing wrong, and where can I find examples on to setup the wireless and encryption settings?

Thanks for any help!

3 Replies 3

vsnl_chennai
Level 1
Level 1

The running config must look something like this .

U can go to the cisco site for further examples and more commands .

Once u finished the document , and than if u have a problem kndly feel free to ask ..

http://www.cisco.com/en/US/products/hw/routers/ps380/products_configuration_guide_chapter09186a008045d289.html

!

bridge irb

!

interface Dot11Radio0

no ip address

!

broadcast-key vlan 1 change 45

!

!

encryption vlan 1 mode ciphers tkip

!

ssid cisco

vlan 1

authentication open

authentication network-eap eap_methods

authentication key-management wpa

!

ssid ciscowep

vlan 2

authentication open

!

ssid ciscowpa

vlan 3

authentication open

!

speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0

rts threshold 2312

power local cck 50

power local ofdm 30

channel 2462

station-role root

!

interface Dot11Radio0.1

description Cisco Open

encapsulation dot1Q 1 native

no cdp enable

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 spanning-disabled

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

!

Regards,

Bramnha Prakash

Hi and thanks for the info. Unfortunately this didn't help me much. I'm trying to avoid doing any bridging if possible. I have basically a Vlan1 (let's say 10.1.1.254) which is part of the "wired" network. I'm trying to configure the Dot1Radio0 to be part of Vlan1 as well so the router can give out ip addresses to the wireless clients and let them get out to the Internet. Is there an easier way to do this? Also where would I configure the shared WPA key?

Currently if I do a: show dott11 associations, it is telling me that the SSID is down because the Vlan associated with it (Vlan1) is down..which it is not since my regular PCs are on the LAN and communicating properly. I just can't seem to find a basic Wireless configuration for this 851. Again any help would be appreciated.

Thanks!

I have the same problem if I follow the sample config. So, I did the following. I hope it helps.

!

bridge irb

!

interface Dot11Radio0

no ip address

ip nat inside

ip virtual-reassembly

!

encryption key 3 size 128bit ***** transmit-key

encryption mode ciphers tkip wep128

!

ssid CICSOTEST

authentication open

authentication key-management wpa optional

wpa-psk ascii 7 ********

!

speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0

54.0

station-role root

no dot11 extension aironet

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 spanning-disabled

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

!

interface Vlan1

no ip address

bridge-group 1

bridge-group 1 spanning-disabled

!

interface BVI1

ip address x.x.x.x 255.255.255.0

ip nat inside

ip virtual-reassembly

!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: