I've never worked with the 851 on the wireless side of things and I'm having a really hard time getting this thing to let me connect with my laptop and give me an IP address. I just want to setup something fairly simple with an SSID (non broadcast), WPA password etc for home use. Here's what I have currently:
Hi and thanks for the info. Unfortunately this didn't help me much. I'm trying to avoid doing any bridging if possible. I have basically a Vlan1 (let's say 10.1.1.254) which is part of the "wired" network. I'm trying to configure the Dot1Radio0 to be part of Vlan1 as well so the router can give out ip addresses to the wireless clients and let them get out to the Internet. Is there an easier way to do this? Also where would I configure the shared WPA key?
Currently if I do a: show dott11 associations, it is telling me that the SSID is down because the Vlan associated with it (Vlan1) is down..which it is not since my regular PCs are on the LAN and communicating properly. I just can't seem to find a basic Wireless configuration for this 851. Again any help would be appreciated.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...