I've loaded APs into a large area map. After adding APs and saving, occassionally after a few hours 1-3 of the APs will spontaneously move on the map, appearing to dissappear. When I search for their specific names, I'll notice their x y's are matching another APs and for some reason they've piggy backed. I have done nothing, it's happening on its own. Anyone have experience with this bug in Prime 1.3? If so any suggestions for resolving this issue? To say its annoying would be an understatement.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...