cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
212
Views
0
Helpful
1
Replies

Problem with AP placements changing in Prime Map

wifiguy1000
Level 1
Level 1

All,

     I've loaded APs into a large area map.  After adding APs and saving, occassionally after a few hours 1-3 of the APs will spontaneously move on the map, appearing to dissappear.  When I search for their specific names, I'll notice their x y's are matching another APs and for some reason they've piggy backed.  I have done nothing, it's happening on its own.  Anyone have experience with this bug in Prime 1.3?  If so any suggestions for resolving this issue?  To say its annoying would be an understatement.

 

Thanks again!

- John

1 Reply 1

mohanak
Cisco Employee
Cisco Employee
Heat map is showing wrong positions in the PI 1.3
CSCuh11786

Symptom:
Prime Infrastructure may display devices in the wrong position when there are more than 15 access points on the floor.
Conditions:

Workaround:
At this time, there is no workaround.

Last Modified:
Jan 28,2014
Status:
Other
Severity:
3 Moderate
Product:
Network Level Service
Known Affected Releases:
(1)
1.3(0.20)
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: