Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Problem with Cisco AP 1142N-K9 configuration

How can I have access to the cisco "AP#" prompt?

When I try to acees the AP through hyperterminal, it gives me the attached messages. The message keeps looping and not letting me access the AP# command prompt to assign an IP address so that I can control it in mode HTTP.

I will really appreciate if I can have assistance with that.

Joseph.

2 REPLIES
Hall of Fame Super Silver

Re: Problem with Cisco AP 1142N-K9 configuration

You have a lightweight AP which requires a WLC. If you need a stand alone autonomous ap, then you need to convert that ap to autonomous. You can search the forum for:

LWAPP to Autonomous

Thanks,

Scott Fella

Sent from my iPhone

-Scott
*** Please rate helpful posts ***
Hall of Fame Super Silver

Problem with Cisco AP 1142N-K9 configuration

650
Views
0
Helpful
2
Replies