Problems connecting two wireless rooters without cable.
How do I set two Roter, if one is already configured. The other is a model Edimax BR-6504n. For the first Roter I know the MAC address and no password ... I connect with any laptop without the password, I am interested in someone who knows better to enlighten me.
I know from the manual that the rooter supports the following options: AP AP Bridge-Point to Point AP Bridge-Point to Multi Point AP Bridge-WDS
And in the MAC section of the AP Bridge-Point to Point I put the MAC of the first rooter, and here is the problem cause I do not know the channel of the first rooter. Is there a program or something that find the channel.
I have access only to the second rooter. And it is important what options to set so that i reduce the number of combination to try when i put the channel. What option should I put to the LAN? to make the ip different from the first rooter? IP of first rooter: 192.168.2.100-200 I think this are the range ip of the first rooter. Should I put the second rooter IP in another range like 192.168.1.*.* or leave it to 192.168.2.*.*?
The problem is that I must link them wireless not by wire.
So how do I connect the second rooter to the first so that I can extend the range of the wireless.
Re: Problems connecting two wireless rooters without cable.
In this mode, you canconnect your wireless rooter with another, to combine two access points and expend the scope of the wireless network, and all clients of two wireless rooter will think they'rw on the same physical network.....etc see the image below.
So i think it must work...but i du not know how to config them.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...