Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Problems with LWAPs and Symbol Spectrum24 Client Bridge

Hello,

I am running a WLC 2006 with a couple of test LWAPs. I have everything running fine except for a Spectrum24 Client Bridge from Symbol. It is using an LA4121 card also from Symbol. Before you guys here flame me it cannot apparently use a Cisco card (or at least that is what the guy that controls this device is telling me). It has to have a static IP on it. I can get it to associate with the LWAP but the IP address shows up as 0.0.0.0 on the controller and it can't pass traffic. When I put the same card in a laptop and give it a static IP I am blazing away with no problems. Has anyone seen this before?

Thanks in advance. All replies will be rated

1 REPLY

Re: Problems with LWAPs and Symbol Spectrum24 Client Bridge

Update: It appears that Work Group Bridges are not supported on the current version of code. A realease due out in May will take care of this issue.

139
Views
0
Helpful
1
Replies