Firstly, i would like to explain my situation, I have a Router EA2700 in first floor of my home, but in second floor, my wireless signal is poor. I tried to use a WAP200 AP to a wireless repeater to increase the signal in second floor.
I configured the WAP200 using the option of repeater. I write the MAC of the EA2700 router and save the config.
First I try using the same SSID and WEP password, but, when try to connect, using the WAP200, i can´t receive IP Adress, and mark Connectivity limited.
Then I reset the WAP200 AP and the first thing to do when i entered, was select the option repeater, the device ask me for WEP password, I wrote and then save. But show me another SSID call Ciscosd, but i can´t connect, and if i choose my principal SSID in second floor continue with my poor wireless signal.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...