I want to configure a 876W router to have a public wireless LAN with internet access only and a wired LAN (different IP network) with an IPsec VPN connected to the companys network.
I want to seperate the two networks putting them into two different VRF groups. I wonder how I should configure the routing and especially in which VRF should I put the common outgoing dialer interface?
The crypto map has to be applied on the dialer but how can I avoid traffic from the WLAN going over the VPN?
Configuration assistance/examples or just hints are very welcome :)
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...