I'm working on a solution to Implement WLC HA v7.5 and have been reading the WLC Config guide v7.5 but looking at the sections within the respetive chapters relating to LAG Config restrictions and HA Config restrictions, I'm not entirely sure that HA is supported with LAG disabled, Can someone clarify please?
You should keep it simple and best practice. Keep lag enabled even if you are only going to use one port on the wlc. When you disable lag, then that is when the configuration becomes tricky and that's why it's not supported.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...