Good morning. We are testing NCS with ISE. We set up a local account on ISE with PEAP- MS-CHAP V2. And we monitor the client through NCS. However, the Endpoint Type of the client is always Unknown or Undetermined. Shall we suppose to see the Endpoint Type of the clients is "laptop, phone, iPhone, iPad, etc." ? If yes, what we could miss in the configuration of ISE or NCS? Please advise.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...