Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Radio going to blocking state

Hi All

The Cisco 1200 WAP, when logged shows me the fowarding state as Blocking.

When the carrier test is run, it shows me as busy. Can any one tell me shat can be the cause.

I suspect the STP should be the issue here.

Regards,

Vijay

1 REPLY
Silver

Re: Radio going to blocking state

Use the resetall command to reset the radio interface. Upgrade the bridge

118
Views
0
Helpful
1
Replies
CreatePlease to create content