Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Radio Interface Resets.

Hi,

we have found a specular error on the radio interface of the Access Point.

Errors on the Radiso Interface area as below.

Dot11Radio0 is up, line protocol is up

47575 output errors, 0 collisions, 4 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier

0 output buffer failures, 0 output buffers swapped out

Please Help me up.

Regards

SRIHARI

3 REPLIES
Silver

Re: Radio Interface Resets.

Reset indicate number of tims interface has been reset. This happens when th packet queued for transmission is not sent within specified seconds. This might be due to a cable problem on serial line or malfunctioning modem that is not supplying transmit clock signals.

New Member

Re: Radio Interface Resets.

Thank you Dear,

But this problem araises on all the AP's that are in the network. so this cannot be a cable problem. What could be reason.

if the radio interfaces are reset frequently what could be the cause.

Regards

Srihari

New Member

Re: Radio Interface Resets.

Are all your access points operating on the same channel? It sounds like some sort of malformed packets that they may be receiving...

368
Views
0
Helpful
3
Replies