Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Radius Issue

i have a user that is only able to use the wireless connection while connected to the LAN. When the user disconnects i am able to see the client assoc but cannot communicated. Any ideas.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Radius Issue

Hi,

Here are few thing which you can check :-

* When it show associated .. do ipconfig on computer ... check if there any ipaddress or not .. if it is not getting ip address .. communication will not take place....

* Assign static ip address for testing .

* If we have the correct ip address ..

Do clear arp on AP once or reboot ..

Then, try to connect again ..

Thanks ..

Pls rate .. it solution works for you so that other can benefit of these steps

2 REPLIES
New Member

Re: Radius Issue

Hi,

Here are few thing which you can check :-

* When it show associated .. do ipconfig on computer ... check if there any ipaddress or not .. if it is not getting ip address .. communication will not take place....

* Assign static ip address for testing .

* If we have the correct ip address ..

Do clear arp on AP once or reboot ..

Then, try to connect again ..

Thanks ..

Pls rate .. it solution works for you so that other can benefit of these steps

New Member

Re: Radius Issue

right direction dhcp scope was distributing worng gateway after scope corrected issue was resolved

121
Views
0
Helpful
2
Replies
CreatePlease login to create content