I have a site in which I would like to configure my 1030 in REAP mode on my WLC4124. I want all of the traffic to stay local. What I'm thinking is that I create an interface with the local vlan at the remote site on the controller (40) then create an AP Group and associate our main WLAN SSID to the new vlan40 interface. Then I apply the AP Group to the 1030 destine for the remote site and turn on REAP mode. Does that make sense? I want to make sure this is done correctly as I'm mailing the thing and will not be there to get the AP up and running should it not come up.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...