Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Recovering from Failed Upgrade

AP Model: AIR-AP1220B-E-K9

We recently tried to upgrade this from VXWorks 12.03T to IOS, but something went wrong. We now get the following prompt only:

c -- Copy file

f -- File dir

l -- downLoad file into DRAM

u -- Upload file

p -- xfer Protocol

n -- coNsole

r -- Run

s -- System info.

I've therefore redownloaded the 12.03T VXworks image file and uploaded it via the console cable using 1K-Xmodem and baud rate 115200. The file appears to upload successfully, so I click r for run, but keep getting the following output:

a -- EnterpriseAP Sys 12.03

a

Inflating "EnterpriseAP Sys 12.03"...

** Error in Compression Codes

*** Bad CRC in File DRAM :00008720

Memory Bank total used left

DRAM 16742624 0 16742624

Config 524288 0 524288

FLASH 7602176 0 7602176

Memory Bank:File address size encoding type flags

*** Decode Error 00000001

I've tried this a few times now and redownloaded the image incase it was corrupt but with the same problem.

Can anyone help me? Cheers!

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: Recovering from Failed Upgrade

Hi Paul,

Have a look at the following;

Verify that the connection settings in the terminal application are 9600-8-None-1 and NO flow control (not hardware or software).

From this doc;

Recover from a Failure

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a008019fea0.shtml#topic2

Part of this comprhensive doc;

Upgrade Cisco Aironet AP1200 to IOS

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a008019fea0.shtml

Hope this helps!

Rob

Please remember to rate helpful posts.....

1 REPLY
Hall of Fame Super Red

Re: Recovering from Failed Upgrade

Hi Paul,

Have a look at the following;

Verify that the connection settings in the terminal application are 9600-8-None-1 and NO flow control (not hardware or software).

From this doc;

Recover from a Failure

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a008019fea0.shtml#topic2

Part of this comprhensive doc;

Upgrade Cisco Aironet AP1200 to IOS

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a008019fea0.shtml

Hope this helps!

Rob

Please remember to rate helpful posts.....

247
Views
0
Helpful
1
Replies
CreatePlease to create content