Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

reload the wireless device image using the CLI on AP 1200

I am trying to reload an image on my AP 1231G-A-K9, and it is not allowing me to go to the ap: prompt when pressing ESC and the flash load#############. Thanks in advance

1 REPLY
New Member

Re: reload the wireless device image using the CLI on AP 1200

You may need to follow the procedure explained below:

Step 1 Set the static IP address of the PC on which your TFTP server software runs to an address between 10.0.0.2 and 10.0.0.30.

Step 2 Make sure that the PC contains the access point image file (such as c1100-k9w7-tar.123-8.JA.tar for a 1100 series access point) in the TFTP server folder and that the TFTP server is activated.

Step 3 Rename the access point image file in the TFTP server folder to c1100-k9w7-tar.default.

Step 4 Connect the PC to the access point using a Category 5 (CAT5) Ethernet cable.

Step 5 Disconnect power from the access point.

Step 6 Press and hold the MODE button while you reconnect power to the access point.

Step 7 Hold the MODE button until the Radio LED turns red (approximately 20 to 30 seconds) and then release.

Step 8 Wait until the access point reboots, as indicated by all LEDs turning green followed by the Status LED blinking green.

Step 9 After the access point reboots, reconfigure it using the access point GUI or the CLI.

HTH

145
Views
0
Helpful
1
Replies
CreatePlease to create content