Remote 350 listed as "unassigned"

[crawdaddy18]

I have two bridges that were communicating perfectly until the remote bridge's ip address became listed as "unassigned". So, now I cannot communicate with that remote bridge.

This looks like a WEP error, but I KNOW the WEP keys are the same.

Any ideas?

Thanks in advance,

Chris.

[#2]

Try upgrading the firmware in the 350 bridge. If that doesn't help, it might be because the 350 bridge might have become faulty.

[crawdaddy18]

I am currently using version 12.04 (VxWorks???). Should I try the Cisco IOS? What is the most current version?

Thanks,

C.