I would like to know if you can specify which MASTER/REPEATER a SLAVE bridge(all bridges are 350) will associate to. We are experiencing difficulties with our slaves picking up the master and not the repeater. There is not total isolation frome the master to the slave so it seems like it is choosing the master over the closer repeater. If you have any info on this topic I would appreciate the advice.
You can specify the mac addresses of the bridges on a non-root (slave) bridge so that it will try to associate to specified bridges in order. Under AP radio advanced page, you can specify those mac address..Pl. visit following link for that
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...