Replacing 4402 Wireless controller

[marc-berger]

Hi all, Not too familiar with cisco wireless yet but I am replacing a 4402 WC that support 25 AP's to a 4402 that supports 50 AP's. I am running 4.1.185 code (upgraded the new one to this code level) and TFTP'd the configuration off the old one to the new one and am going to replace it. I was wondering if anyone has learned of any "gotcha's" during a replacement like this or is it just straigt forward unplug the old and plug in the new one?

[sharon-b]

hi, just backup the configuration on the old 4402-25, and restore in on the new 4402-50. it should work.

[marc-berger]

cool...that is what I have done. I will give it a try and see what happens. Thanks for the help