Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Replacing 4402 Wireless controller

Hi all, Not too familiar with cisco wireless yet but I am replacing a 4402 WC that support 25 AP's to a 4402 that supports 50 AP's. I am running 4.1.185 code (upgraded the new one to this code level) and TFTP'd the configuration off the old one to the new one and am going to replace it. I was wondering if anyone has learned of any "gotcha's" during a replacement like this or is it just straigt forward unplug the old and plug in the new one?

New Member

Re: Replacing 4402 Wireless controller

hi, just backup the configuration on the old 4402-25, and restore in on the new 4402-50. it should work.

New Member

Re: Replacing 4402 Wireless controller

cool...that is what I have done. I will give it a try and see what happens. Thanks for the help

CreatePlease to create content