I am working with a set of four 4402-50 controllers all running 4-0-219-0. The customer decided they did not want the Secondary and Tertiary controller settings configured on the AP so I am attempting to clear that information but I can't seem to do it. No matter what I change it to the settings stay the same. Even if I reset the AP to factory default, when it comes back up it does so with the secondary and tertiary controllers set. It clears out all the other configuration info, such as the primary controller, the name, radio settings, location, etc. It just won't get rid of the secondary and tertiary info. Has anyone seen this behavior?
I've tried setting it back to default through the CLI on the controller and through the web interface on the controller.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...