Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Resetting AP1131

We have an AP1131 access point which was installed by a previous technician. He left, without leaving the password details!

So I performed a Factory Reset, using the Mode button, as per the manual.

  • Hold down the Mode button
  • Re-insert the PoE injector
  • Wait for the Ethernet light to go orange
  • Stop pressing the Mode button

The unit then re-initialises, the Ethernet light goes green but the Radio light doesn't come on.

What do I need to do?

Regards

Adrian

2 REPLIES
VIP Purple

Hi Arian,Since you  reset to

Hi Arian,

Since you  reset to factory defaults there may not any configuration on it. So without SSID configuration radio interface may not come up.

You have to console in to this to configure it using CLI. Otherwise you can try to access it via GUI using the default IP address (credential should be Cisco/Cisco)

 

HTH

Rasika

**** Pls rate all useful responses ****

Bronze

You would have to reconfigure

You would have to reconfigure the AP using the default IP Address or console into the AP.

94
Views
0
Helpful
2
Replies
CreatePlease login to create content