Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Rogue Detection (LWAPP):

What port config should be used for a LWAPP in 'rogue detection'.

Should this be a trunk port or an access port.

Please advise.

4 REPLIES

Re: Rogue Detection (LWAPP):

It has to be a trunk, because the rogue detector is used to detect the ARP requests, so you need to connect it to a trunk so that all ARP requests from all VLANs are detected.

Hope it helps

Jerome

PS: please also check in this forum, there were a couple of threads about how to configure this AP and its trunk port.

Re: Rogue Detection (LWAPP):

Jerome... great response... I did not know that ... thanks for sharing ...

__________________________________________________________________________________________ "Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin ___________________________________________________________
New Member

Re: Rogue Detection (LWAPP):

What native VLAN will I use for the trunk port. The WLC is currently using VLAN 50 as native VLAN.

Re: Rogue Detection (LWAPP):

Hello,

I've also been trying this out with mixed results! I found that when the Rogue Detector's trunk had the native VLAN set to the same as the WLC's management interface it worked fine. However, when set to the local VLAN that the AP would normally reside in (seeing as I wanted to retain an L3 topology) it would not discover that a test rogue was on the LAN. Any ideas????

Thanks

Rich

297
Views
5
Helpful
4
Replies
CreatePlease to create content