10-30-2008 10:35 AM - edited 07-03-2021 04:42 PM
I'm using AIR-LAP1522AG-A-K9 and Enterasys switch.
How should it be the spanning tree configuration in the ports where are connected the Root Access Points
STP should be enabled or disabled?
10-30-2008 12:10 PM
I have never had to enable spanning tree on any access point. Leave that alone unless you require it for some odd reason... like in this doc:
10-30-2008 04:56 PM
How could i prevent loops between the wired switch and the radio A when i have two RAPs connected to the same switch and one of them loss connection with the ethernet interface for a while
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: