Root Bridge+Clients with Non-Root Bridge+Clients Howto?
Hi, i have two 1242AG access points. I would like to setup a bridge between the two to bridge ethernet lan segments, furthermore i would like to be able to connect wireless clients to either of the access points so i can get maximum range.
I did what i thought was correct, created the first access point a 'root bridge with wireless clients', and assigned the ssid.
I set the second access point to 'non-root bridge with wireless clients' amd set the same ssid as the first access point.
I cant even get the root bridge to work, i turn it on, it brings the radio interface up but i cannot connect with my wireless clients, infact i cannot even see the SSID!
Do i need to 'Set Single Guest Mode SSID' for the radios? What does that command do?
Any ideas? A link to config example would be much apreciated.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...