The 1250 is THE monster for ruggedized AP. It is built around a steel enclosure/chassis. Take note that the 1250 has one major sticking point that alot of users tend to forget: without a WLC, the AP needs 18.5 watts of power (ePoE) to operate both radio modules.
If your switch is unable to provide ePoE (and you don't have a WLC), then you can get a power injector or remove one of the modules.
If you plan to have the 1250 join a WLC, use the latest firmware, 5.2.X, and it should be able to operate (with both radio modules) at 15.4 watts.
Are you sure you can operate both radios using 5.2 and 15.4mW. The 1250 requires at least 16.8w and that means the 2.4ghz will run on reduced power.
AP1250 with two RM1252 radio modules installed: 18.5W
AP1250 with one RM1252 radio module installed: 12.95W
Note: For a 1250 Series Access Point with two radios, 18.5W is the maximum power required at the access point (powered device). When deployed using PoE, the power drawn from the power sourcing equipment will be higher by some amount dependent on the length of the interconnecting cable. This additional power may be as high as 1.5W, bringing the total system power draw (access point + cabling) to 20W. A similar consideration applies for a 1250 Series Access Point with one radio.
We have a couple of installs with 1250's where only standard 802.3af power is being used currently. It will power both radio modules but you lose the 802.11n capability. The WLC version we are running is 220.127.116.11.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...