Currently we have a WLC anchor controller running V4.2.130 . And it has one real Guest wlan which is directed to the Internet .
I would like to know if we can configure another Guest-like wlan on the same anchor WLC. The aim is to create a second Guest-like wlan on our anchor WLC and direct it to our internal firewall . So that users associating to this Guest-like wlan no matter where they are located in our network get a dhcp address in the same subnet and we can configure our internal firewall so that these users are limited to certain resources .
If it is possible , can you provide an example of a setup ?
Each Anchor can support up to 71 EoIP tunnels but only one from each controller. So no, it is not supported by Cisco at this time. These controllers can be from different mobility groups but only one tunnel per WLC is currently supported. Stay tuned as the next generation of controllers is unveiled. You will see some significant changes with how these controllers operate.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...