Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Setting up AP in Sniffer mode

Looking for information that the sniffer trace just doesn't show me.

I have the AP setup in sniffer mode. I went to the controller that the AP is homed to. I'm capturing the data to wireshark.

I'm debugging the packets as AiroPeek. I can't seem to capture the clients initial connections i.e. dhcp request and handshakes.

Have I missed something ?

1 REPLY
Hall of Fame Super Gold

Re: Setting up AP in Sniffer mode

I'm not sure what firmware version you've got, but try this:

Configuring Wireless Sniffing

http://www.cisco.com/en/US/docs/wireless/controller/5.1/configuration/guide/c51err.html#wp1042843

Hope this helps.

206
Views
0
Helpful
1
Replies
CreatePlease to create content