I'm trying to interpret output from the 'show dot11 statistics client-traffic' command in autonomous IOS version 15.2(4)JB4 on a 3600-series access point. Finding a detailed description of each data point being reported has been very difficult - c'mon Cisco! For my purposes I'm most interested in what is being reported in the 'Retry' and 'RSSI' fields. It seems like RSSI in dBm is being reported but I'd like confirmation from someone who knows because in older versions of IOS it seems like this value might have been a percentage value on a scale of 0 to 100% with 0 being -113dBm and 100 being -10dBm.
Here is a sample of the output from my access point:
SURVEY_AP1#show dot11 statistics client-traffic
Dot11Radio0: -- Client Statistics ---Clients 0 AID VLAN Status:S/I/B/A Age TxQ-R(A) Mode Enc Key Rate Mask Tx Rx BVI Split-ACL Client-ACL L2-ACL RxPkts KBytes Dup Dec Mic TxPkts KBytes Retry RSSI SNR (Client) MaxPri DefUniPri DefMultPri WiredProt IP Address Pauses Idle RateTx RateDataTx RSC MVL Req=0, In=0 Video Report: Cnt Rate Retries/Tot 8021x auth in prog 0 allowed 0
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...