11-19-2010 11:58 AM - edited 07-03-2021 07:26 PM
I have a remote site that would like to add wireless access. They do not have a domain controller or DHCP, everything is set statically (but on a separate subnet). There is only 1 PC and 2 laptops.
If I pre-configure an 1131AP with the controller information and a static IP address, will this work? Would it be better to just give them an autonomous AP?
11-19-2010 12:51 PM
Yes, if you prime the AP locally, then send it to the site, it should work just fine. How this sounds, I would go with HREAP for that AP though. As this is a very small site, you could do IOS as well. IMHO I'd go IOS for this setup.
HTH,
Steve
*Please remember to rate helpful posts*
11-19-2010 01:07 PM
Thanks, I'll give it a try with HREAP. For managability I'd rather have it tied into the controller rather than using IOS.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: