Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Single 1131AG AP in a static site - no DHCP.

I have a remote site that would like to add wireless access.  They do not have a domain controller or DHCP, everything is set statically (but on a separate subnet).  There is only 1 PC and 2 laptops.

If I pre-configure an 1131AP with the controller information and a static IP address, will this work?  Would it be better to just give them an autonomous AP?

  • Other Wireless - Mobility Subjects
2 REPLIES

Re: Single 1131AG AP in a static site - no DHCP.

Yes, if you prime the AP locally, then send it to the site, it should work just fine.  How this sounds, I would go with HREAP for that AP though.  As this is a very small site, you could do IOS as well.  IMHO I'd go IOS for this setup.

HTH,

Steve

*Please remember to rate helpful posts*

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
New Member

Re: Single 1131AG AP in a static site - no DHCP.

Thanks, I'll give it a try with HREAP.  For managability I'd rather have it tied into the controller rather than using IOS.

311
Views
5
Helpful
2
Replies
This widget could not be displayed.