Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

snmp traps will not stop

We are getting a ton of snmp "cold start" traps. About every minute or less. I even took the statement out of the configuration to stop the device from sending those traps but they're still coming.

I used the "no snmp-server traps enable snmp coldstart warmstart"

I verified that it was no longer in the config as well. Any help?

3 REPLIES

Re: snmp traps will not stop

Is this for a specific interface? if so try "no snmp trap link-status" in the interface config.

HTH.

New Member

Re: snmp traps will not stop

These are coming from our wireless access points. We dont want to turn off all status traps on them either.

Hall of Fame Super Silver

Re: snmp traps will not stop

Are your ap's bouncing? I have only seen this when the ap is on the secondary controller and fails to joins its primary.

-Scott
*** Please rate helpful posts ***
128
Views
0
Helpful
3
Replies
CreatePlease to create content