I have a Bridge group 2 configure with a BVI interface, this is also bridge onto VLAN 2 so I have a server on VLAN 2 which acts as a media server.
when I connect to the WLAN I can get to the internet. But cannot connect to the server which is on the same vlan. when I do a show spanning tree I can see it is disabled on the dot11radio0.2 interface.
I remove the bridge-group 2 spanning disable and sure enough everything works.
on reboot spanning tree is disabled again.
Should I be doing this a bit differerntly to joing vlan 2 and the radio interface?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...