Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Spectrum Expert using 15.2(2) on Aironet 3600

After trolling the interweb for some time, it seems that it's possible using a 3600 ap and Spectrum Expert together to do wireless surveys. Has anyone done this successfully? How is this possible without a NSI key? Excuse my lack of knowledge on the subject, as I'm very green to wireless. But I have situations where'd like like to get pre-reading of the RF interference before the install. Rather than pay someone to do so.

 

Anyone have experience or a good link to read up from? Or am I just missing something on the CSC?

1 REPLY

Hello kevintruex100,I do have

Hello kevintruex100,

I do have the NSI Key when using Cisco 3600 AP.

If your AP is in standalone mode, go to Network > Network Interface and select the radio interface (Radio0-802.11N 2.4GHz or Radio0-802.11N 5GHz. After that select Settings and than Spectrum. 

This will do the AP work as a Spectrum Analyzer.

 

Click on Spectrum Information and you got the NSI Key.

 

Regards.

 

122
Views
0
Helpful
1
Replies