Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Spectrum24 Client Bridge to LWAPP AP isnt working

We have several GE MAC5000 EKG Carts that use a Spectrum24 Client Bridge (CB-1000-0000) that has a Symbol PCMCIA 802.11b card in it. These work fine with our autonomous APs but will not work on our new LWAPP wireless network. It does associate but if I look at the controller at the details of the client it shows an IP address of 0.0.0.0. These are statically assigned and I do not require DHCP for the WLAN it is associating to. Anyone have any ideas for me? Thanks.

1 REPLY
New Member

Re: Spectrum24 Client Bridge to LWAPP AP isnt working

Are the CB-1000's showing up in the Client Exclusion List.

Are your LWAPP AP's using the same IP Scheme as the Autonomous AP's?

I have had problems with other Symbol gear (wireless barcode scanners) and Zebra wireless printers when trying to use static addresses once AP's were converted to LWAPP - I would get a similar situation that you are describing.

I ended up using DHCP but putting in a reservation for those devices with the IP address I wanted to use.

303
Views
0
Helpful
1
Replies